Viessmann VITOCELL 100-V Manuel de service télécharger pdf (Page 8)

5608 487 v1.2

Vitocell 100-V Installation Instructions

42 to 79 USG (160 to 300 Liter) Tank Installation

Thermal insulation and thermometer installation

All required components are included in the insulation

jacket carton.

1. Position and level the DHW tank with its leveling bolts.

2. Mount sensor on the outside of the sensor spring-clip

(not in the center groove) so that it is flush with the

front of the sensor spring-clip.

3. Snap sensor cabling into plastic clip of sensor

mounting equipment.

5. Remove top cover and insulation blanket.

6. Remove cap from thermometer opening.

7. Slide thermometer sensor cable through thermometer

opening in the panel and insert thermometer.

8. Completely insert sensor into metal clip on flange

(check anode connection on page 8). Install the

insulation blanket and top cover.

IMPORTANT

Do not extend the leveling bolts beyond an overall

length of 1½ in. (35 mm).

Note: For applications with Vitotronic 100 control,

use supplied plastic clip and two screws to

secure Honeywell bulb capillary. For applications

with the Vitotronic 200 or 300 control option,

use supplied plastic clip and two screws to

secure sensor cable to the tank sheet metal.

Note: For Solar Domestic Hot Water with Vitosolic 200,

SCU 124 or SCU 224, use supplied plastic clip

and two screws to secure sensor cable to the

tank sheet metal.

4. Completely insert sensor mounting hardware along

with sensor into sensor well.

Note: the 42 to 79 USG (160 and 300 L) tank comes

with the insulation jacket installed.

IMPORTANT

Never wrap insulating tape around the sensor.

Set-up and Connections

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Pas de commentaire

Viessmann VITOCELL 100-V Manuel de service Page 8